Equipped With

16 GA. X 52” ACRA MODEL FS-P5216A PNEUMATIC (AIR) POWER METAL CUTTING SHEAR

• Front and Back Sheet Metal Plates Covered To Safety & Protection System.
• Guarded “Foot Switch” for More Convenient to Operation and Safety.
• Operator Control Cutting Action for BURR-FREE Shearing Operations.
• Maximum Gage Capacities are Applicable When Using Mild Steel.
• Frames & Table Made by High Tensile Cast Iron.
• The Shearing Blade Made by High Carbon-High Chrome.

Specification:
Capacity:                                         16 Ga. X 52”
Cutting Capacity (Mild Steel):         16 Ga.
Cutting Capacity (Stainless):            20 Ga.
Rake Angle: 1 Degree,                     48’
Cutting Angle:                                 1.8 Degrees
Table Height:                                   31.7”
Back Gauge Range:                         27”
Front Gauge Range:                        26”
Air hose length:                              7 ft.
Maximum Air Pressure:                   85-100 psi
Air consumption:                            25.4 cfm
Air consumption per stroke:           1.4cfm
Strokes per Minute:                         40 without load; 20 with load
Air Hose diameter:                          1/2″
Air Hose inlet (NPT):                        3/8”
Voltage:                                           110V
Weight                                            1210 lbs


• Foot Pedal.
• 2 Front Arm Extensions.
• 1 Front Stop, with hardware.
• 1 Rear Stop, with hardware.
• 2 Scale Rods.
• Air Regulator.
• Pressure Gauge.
• Check Valve.
• 2 Adjusting Block Assemblies.
• 1 Bevel Gauge, with hardware.
• Toolbox.
• 1 Instructions and Parts Manual.
• 1 Warranty Card.